Search results

Thought would share this from my 2011 36k km 200THP. Noticed oil patch on car stand getting worse and seemed to be coming from upper back of engine on drivers side. Difficult to get into see or feel so removed the plastic pipe and steel bracket that sits on right engine mount. Popped in mirror...

Seems I have the intermittent coolant gauge issue where shows nil, shows red with stop car warning, sits in middle, sits at 30% etc. From what I see it is probably due to a faulty sensor and this is where I’m a bit confused as see comments that the sensor is integral with the thermostat housing...

Hi 2011 RCZ, 200 petrol. Climate control unit in the car which I understand is also the ECU does not light up at all, seems dead. Subbed with another unit and same. I’ve checked the 12v feed and good. Earth line (pin 4 on black connector) is a strange one. Shows resistance to earth of about...

Hi all. I have a damaged flexi water hose (seems driveshaft has been touching it and worn) that goes up to the back of the engine - 1.6 petrol - it’s the pipe connected directly to another pipe that goes to the bottom of the coolant expansion tank. it seems a bit of a bu**er to get access to...

Hi all I am a bit stumped at moment. Drivers window goes down but not up. In fact started to go down by itself in fits and starts so had a thought it might be anti-pinch kicking in. However that stopped and now only down, nil up, no relay noise when trying up in small control unit attached to...

Hi all, I’ve got a non starting 2011 RCZ petrol. I noticed a missing relay (or an empty socket to be more specific). Hanging in front of the engine compartment fuse box, photos here. Any clues as to what this serves? I have spent a few happy hours wading through Sedre with no joy. And spec of...

Hi, I have a 2011 model, just fitted second hand bonnet. Generally ok but could be better fit along door edge and a bit high at back so has anyone any tips on bonnet alignment that might help? Old ways on a 1971 MG of a block of wood and “lean on it” don’t seem quite right here! Cheers.

Hi, I’m new on here, hello to all. I’m stuck with an issue in that my driver’s window is stuck in the fully down position. I can hear the motor clicking if I hold the down switch but nil when I try to raise. I’m trying to remove the glass to get access to the motor (ie panel is off and I have...