A
Anonymous
Guest
Stop being pedantic. We are known for being off topic. That's how we are. If you want serious............. look in the mirror :lol: Lancashire humour. Sorry just in that sort of mood :wave:merchant seaman said:
Peugeot RCZ Forum
Register a free account today to become a member. It's free! Once signed in, you'll be able to participate on this site by adding your own topics and posts, connect with other members through your own private inbox and take part in competitions!
A
Anonymous
Guest
Supernatural Fine Cut Metal Polish, very good by hand, seen it used on donna's car extremely good results
i'm going to try Gtechniq P1 and P2 by machine (DA only, rotary would heat up the metal too much and could take it off far to easily)
seal with Gtechniq C1 and C1.5!
i'm going to try Gtechniq P1 and P2 by machine (DA only, rotary would heat up the metal too much and could take it off far to easily)
seal with Gtechniq C1 and C1.5!
RCZ1
Active Member
daniellll.bee said:
You're brave !
Mine are currently sealed with C1.5.
A
Anonymous
Guest
I know/stupid! Haha
What were your paint depth readings on the arches?
I was gunna check on Friday but forgot all about it until I read this!
What were your paint depth readings on the arches?
I was gunna check on Friday but forgot all about it until I read this!
RCZ1
Active Member
They were extremely low. Can't remember exact figures but they are on here somewhere. Highest was on the very top but only about 50 microns, going down to 20 microns.
A
Anonymous
Guest
Ill have a check when I do it!
A
Anonymous
Guest
I tryed P1 on arches by hand, and with DA and with rotary on 900 rpm( lowerest speed)and I used only finish pad on it. In each case, the paint remained on the pad a little bit. But finish was superb. You need to be very genle with it.
A
Anonymous
Guest
RCZ1 said:
My bonnet was 110...... not sure about anywhere else though.....