A
Anonymous
Guest
Hi tianorth & DKZ5745, I had some time today so had a go at getting access to the parking sensors, There are five allen screws and four push fit fixings, well I think that's about right. I was able to remove the housing shown as Item No3 in the diagram which fits to the bumper that incorporates the fog/reversing light and the twin exhaust pipes, although the housing would not come completely off due to something holding it at the left hand side viewed from the back I think it was something to do with the twin exhaust pipes. However, when it was lowered it still gave me full access to all the parking sensors and wiring. If I could have compeletly removed the housing it would have been far easy to refit the bracket and sensor to the bumper, but as I have sold the car all I wanted was to get it held in place and working which I have now done. I am sure if the Peugeot garage had a body shop they would have been able to get the bracket and sensor refitted, and not say it's a complete bumper replacement at a cost of £600+, I did check with a private body shop and when I showed him my sensor bracket I was told the brackets are all very similar and can be removed from old bumpers and glued to back to another bumper. Well I have achieved what I set out to do and now have all the sensors working again, it would be nice to have a look at the electrical service manual as I am sure you should be able to short out two pins to make the circuit think there is a working sensor fitted should one go down. Thanks to all how replied and the information they gave. :beer: HB