Hi all
I am a bit stumped at moment. Drivers window goes down but not up. In fact started to go down by itself in fits and starts so had a thought it might be anti-pinch kicking in. However that stopped and now only down, nil up, no relay noise when trying up in small control unit attached to motor either.
I have dismounted regulator unit from car, taken a look. Was a bit of water in motor, but no corrosion from that. Dried, cleaned. Ran motor manually both ways on the bench with controller unit popped out (ie direct supply to motor contacts) and regulator goes up and down smoothly.
Swapped controller with unit from passenger door motor (identical) but same - down but not up.
Fitted spare door switch unit, same problem, down but not up. No glass fitted and regulator outside door so no real load.
Ran Diagbox and can see that switch is working ie Diagbox notes actuation of door window switch.
In fact when I run the actuator in Diagbox it opens closes passenger window fine, and also seems to think it’s done same on drivers side which not!
Any ideas?
I am a bit stumped at moment. Drivers window goes down but not up. In fact started to go down by itself in fits and starts so had a thought it might be anti-pinch kicking in. However that stopped and now only down, nil up, no relay noise when trying up in small control unit attached to motor either.
I have dismounted regulator unit from car, taken a look. Was a bit of water in motor, but no corrosion from that. Dried, cleaned. Ran motor manually both ways on the bench with controller unit popped out (ie direct supply to motor contacts) and regulator goes up and down smoothly.
Swapped controller with unit from passenger door motor (identical) but same - down but not up.
Fitted spare door switch unit, same problem, down but not up. No glass fitted and regulator outside door so no real load.
Ran Diagbox and can see that switch is working ie Diagbox notes actuation of door window switch.
In fact when I run the actuator in Diagbox it opens closes passenger window fine, and also seems to think it’s done same on drivers side which not!
Any ideas?