Search results

It’s because of the aftermarket air intake pipe you have on it, there is nowhere to plug the air sensor into with them. Yellow circle shows where it should be. Can affect mpg and a few other things, thread link below showing another one ‘modified’ with bits left with no homes...

My money is on the heater matrix (so long as there is no coolant loss, and the car is steady 90deg) as the heater matrix is badly positioned in them, near a 45deg angle and the way they are connected into the water system the coolant is not pushed, basically just using the heat rises theory. Any...

I’ve done same, seat movements work but heat and memory don’t. I found that the configuration in the BSI configuration is default to; heated seats = not present memory seats = not present Having tried with the scanner I have when I change them to present I get a message something about software...

They all seem to leak at the rocker cover gasket, age and heat cycles seem to go for them quicker than most other engines. It’s a bit fussy to get them off, the other pipes etc in the way first. Just make sure you clean it to a squeak on the cover and the head, no sealant except for the tight...

Very tidy, now get some speed limits broke.

It’s disengaged when cold, (speeds up warm up time) but as you have 40 miles+ done at a steady 90c so you can tick that off. Mayo staying away on decent runs, so prob just condensation. Monitor oil and water for a few days/weeks and start enjoying. pics??

broke again after your run of weld and loctite? There has to be another factor playing a part. When you are replacing them make sure your are getting the threads as clean as possible, some brake cleaner into the threads and blow out with an airline perhaps. When you torque it, it should be...

There isn’t really much play about the front bumper skin, location tabs near position it. Couple of pics might help. The red circled grommets/bump stops to the front can be adjusted slightly to lower the bonnet a little to level it with the wings The bumper has tabs that go through the locating...

The module info is in the electrical gremlins just above. Good luck.

Potentially the rear engine mount, but I might be inclined to change all mounts, inc gearbox as they are all same age after all. I believe they were born to be driven with a bit of gusto so get em changed and roar on. Have the front suspension arms and the strut top mounts checked too while the...

https://www.peugeotrczforum.com/threads/electrical-gremlins.17381/post-175683 There was a thread on the forum about a member that fitted a brand new Bosch alt and to put it quite simply, the car did not like it. New alt from Peugeot sorted him out.

Awful thing to have happen. During the job the battery should have been disconnected, it could be that during the disconnection or reconnection the battery control module got blown. If this is popped it could give you most of your issues, including being stuck in economy mode. Depending what all...

The dual mass flywheel could be reaching the end of its service life, springs gone slack in the discs giving you a strange bite, judder. Could have had a spirited driving style, hard not to 😀. 80k is in the window of clutch life depending on those things. When your getting the clutch done it is...

Get some pics up, ooohs and aaahs follow quickly. Health to enjoy your new toy and welcome to the forum.

https://www.peugeotrczforum.com/threads/leather-care-products.18535/ few different ideas on the subject, but should give you some info.

You might still get a genuine, used in the 308’s and Citroen for some time after the RCZ finished. If you do get stuck with waiting times I bought two full sets (not oem) when one of mine failed I can pop it in the post. Was due to rust growth pushing it forward wearing it through on the tip, if...

The external diodes were on the early cars, I think pre 2012. It was then integrated into the abs pump. If there isn’t a box about the size of a cig pack on the lower front of you battery (or your up the years) it’s integrated.

Pic of what it looks like, and if you remove the air pipes circle in red along with the noise box you will see it. Before you jump to replace there is a relay box (from memory) attached at the front of the battery box that has four 1 amp diodes in it along with a couple of other bits, it can...

Have you an idea of a price in mind, with and without the reg? Might help to move it on having a bit of an idea where you think it’s at. Wife just said no, unless something goes…….hmmm.