Valve stem oil seals

[Friday]

Has anyone experience in changing the valve stem oil seals on an rcz 156?

I plan to use the rope method to change the seals and need some advice on the specific valve spring compression tool that is best. The engine is fairly tight so I’m looking for a tool that fits the space plus makes swapping the collets simple.

Also, the timing tools for the engine look quite cheap - anyone with bad experience of using cheap timing set on this engine?

I’ve asked AI and am convinced AI will be the death of many an engine.

 

[Pedro]

Depending on Mileage if heavy Carbon Build up if the valve chambers & valve seats are clogged up changing seals will not fully cure the problem

 

[gwest]

I'm thinking I might just change the exhaust valve stem seals on my 124k km RCZ THP200. I don't think the carbon buildup would be too bad at this mileage and it would be interesting to see how much difference it makes to my oil consumption. I saw a tool on Aliexpress that seems to have quite a versatile setup for doing the job without removing the head. I don't think it would be worth trying to use it on the inlet valves because of lack of room for dealing with the complicated business of removing the variable valve height mechanism

 

[Charlie1875]

Hi, I’ve done this job on a low mileage Mini Cooper s, same engine as it puffed blue smoke whilst in traffic,
you will need an air compressor to stop the valves from dropping into the combustion chamber, also you will have to do all the valves as the carbon builds up in the inlet valves, an ok job to undertake for a fairly experienced diy mechanic.
hope that helps.

 

[Friday]

Thanks all. I'm trying to prepare the tools so the car is not off the road for too long. I am wondering about compressing the rearmost valve springs (inlet valves I believe). I've got this type of compressor (compared to gwest's type above) but now thinking it'll struggle with the rear valve springs due to lack of room in the rcz. Anyone got experience in removing the inlet valve springs with the head still attached?

If there's room I will spin the lever 180 and press down near the bulkhead side. If no room I'll try fitting the valve pusher arm on the other side of the lever and pull the lever up keeping the same orientation? Worst case scenario could be do the exhaust side then chop the lever and fabricate a dogleg extension that fits the space needed for the inlet valves.

I haven't got the valvetronic stuff to worry about given mine is the 156. This link is an interesting take on replacing the valve seals on the 156 engine without removing the camshafts. https://www.forum-peugeot.com/Forum...ueue-de-soupapes-sans-démonter-les-aac.130490 (its in French so you'll need to translate the page)

 

[Charlie1875]

That tool is ideal, there’s enough room to do all the valves, do all 4 valves stem seals in each cylinder then move on to the next cylinder, hope that helps