3rd time about this one. Bought new rear abs sensor, haven't fitted it yet as upon looking at the wiring from the loom that the sensor fits into has snapped?
Talking the wiring part from under boot area. Not the sensor itself.. The actual wiring the sensor plugs into.
Any one had this happen?
Is so what's the repair for it?
Simple get new connector block and repair/ re wire it further back on wire? Or is it a full loom job?
Also noticed jacking point is bent up.
Had it 3 weeks and this.. Gutted isn't the word
Talking the wiring part from under boot area. Not the sensor itself.. The actual wiring the sensor plugs into.
Any one had this happen?
Is so what's the repair for it?
Simple get new connector block and repair/ re wire it further back on wire? Or is it a full loom job?
Also noticed jacking point is bent up.
Had it 3 weeks and this.. Gutted isn't the word