Hi All
I recently replaced my cabin air filter. The filter I bought is shown in the picture. It has an extra edge on the side that goes toward the rear of the car and an edge located where the slot is. I'm not sure how this extra edge should be folded. I folded both edges upward (see photos). This created a gap between the bottom of the filter and the slit. If I understand correctly, air enters through the round hole, then through the filter, and down. So there shouldn't be any gaps? Could you please tell me if I installed it correctly?
I recently replaced my cabin air filter. The filter I bought is shown in the picture. It has an extra edge on the side that goes toward the rear of the car and an edge located where the slot is. I'm not sure how this extra edge should be folded. I folded both edges upward (see photos). This created a gap between the bottom of the filter and the slit. If I understand correctly, air enters through the round hole, then through the filter, and down. So there shouldn't be any gaps? Could you please tell me if I installed it correctly?