Recent content by FAT STICKMAN

Had a similar problem. Check after car gets to 85degs if rad is hot top to bottom if not water system needs bleeding peter

Remove the liner from inside the boot then unplug wiring from the motor, on the end of the motor shaft there is a socket for allen key wind this to raise or lower spoiler manually . Peter

My 2012 rcz 1.6 petrol still got front splitter to fit peter [email protected]

Hi I need a motor and cable drive for my 2012rcz wondered if someone was breaking a car and had one for sale. peter

Thanks for reply turned out to be air lock fixed with temu vacuum fill ki ( cost £13) Thanks again peter

Thanks for help have now fixed the problem it was airlock in the system drained system and refilled with vacuum kit ( temu £13) peter

After 2 mls car misfired temp shows 9o degs top hose hot bottom hose cold engine light on Removed battery lead and replaced it 2 miles later top and bottom hose hot temp 85 legs no missfire no engine light fine for the rest of the day. Peter

1.6 rcz 2012 II run the car for one mile starts misfiring cooling fan comes on shows 90 on gauge radiator cold. I take the positive lead of for 30 seconds then reconnect, all runs fine hot rad temp 87 fine for rest of the day any ideas. Thanks peter

Found the problem the motor has burnt out now looking for replacement motor thanks for your help peter

Can anyone tell me the location of the fuse for rear spoiler on 2012 rcz 1600 petrol rhd I removed it while wrapping the car now cant raise it to refit spoiler thanks peter

Please contact me when you get back Peter

Wanted operator manual for 2o12 1.6 rcz p,[email protected] Located in Suffolk uk thanks peter

I want better headlamps what is suggested better bulbs or LEDs any advice appreciated

I HAD TO MOVE MINE WHEN I FITTED LAMBO DOORS JUST TURN THEM 90% AND MAKE BRACKET TO HOLD THEM FAT STICKMAN