Peugeot RCZ Forum
Register a free account today to become a member. It's free! Once signed in, you'll be able to participate on this site by adding your own topics and posts, connect with other members through your own private inbox and take part in competitions!
Latest activity
-
RI have this available to share with the forum if of any use to anyone and it doesn't infringe forum rules. Can any of the mods verify if...
-
PPeterg replied to the thread RCZ wont start.... sometimes.Hello, thank you.... yes, you will see from my above posts that my electrician believes it to be the auto gearbox ECU.... which I think...
-
Success ! Filled the matrix with Radflush (all I had to hand) and left overnight. Flushed and reverse flushed a few times, a few bits... -
If it were me I would reassemble and retest for any change before spending on a part you might not need ; You might lose a little time... -
I used the stuff below to assist when flushing, descaling etc, think I sort of listed out before, but two extension hoses on the matrix...
-
chrismac replied to the thread Heater Matrix.Success ! Filled the matrix with Radflush (all I had to hand) and left overnight. Flushed and reverse flushed a few times, a few bits...
-
-
PPeterg replied to the thread RCZ wont start.... sometimes.Thank you.... but once again we have done that as well. Changed the BSI/BCM, changed key battery, checked out the ignition switch etc...
-
Iindoldn replied to the thread THP200 Won't start, F303 Fault: configuration.Good point, thanks for that. Before the non start issue, I thought, it could be sensor issue and was planning to try to replace it...
-
Iindoldn reacted to EddieJ's post in the thread THP200 Won't start, F303 Fault: configuration with
Like.
It’s possible one of you engine temperature sensors is faulty, or the split loom for the temp sensors has a wire that is chaffed through... -
EddieJ replied to the thread Heater Matrix.I used the stuff below to assist when flushing, descaling etc, think I sort of listed out before, but two extension hoses on the matrix...
-
-
EddieJ replied to the thread THP200 Won't start, F303 Fault: configuration.It’s possible one of you engine temperature sensors is faulty, or the split loom for the temp sensors has a wire that is chaffed through...
-
PPeterg replied to the thread RCZ wont start.... sometimes.Thank you. I will get the electrician to double check. The electrician can, however, start the car quite easily by putting 2 of those...
-
JJvdBosch replied to the thread RCZ wont start.... sometimes.Mine wouldn’t start sometimes. In the end it was a not well tightened negative battery lead.
-
PPeterg replied to the thread RCZ wont start.... sometimes.From what I have read it could be.. The BMS ...... battery management system The BCU ...... battery control unit The BCM...... body...
-
IHi all, have not posted for a while. Having issue with my THP200. Info below. Early Feb, changed the oil. I had driven it previously to...
