Valex
Active Member
- Joined
- Jan 29, 2021
- Messages
- 165
- Reaction score
- 118
- Points
- 43
- Location
- The Netherlands but Italian :)
I have already a rear mirror with an integrated display and front camera, I would like to connect to it also the rear camera.
I'm going to place the camera near the rubber button that opens the trunk (sorry boot ) and I need to find a way to enter the wire in the boot.
Inside the boot, I removed the black plastic that covers the bottom part of the latch but under it, there is no way to reach the wiring of the rubber button or the license plate lights.
Is it possible to do this job without removing the entire bumper?
Extra story ...
Noticing all the dirt around the rubber of the boot I decided to clean it with a small sponge, water, and dish soap. Not satisfied with the first wash I decided to remove all the rubber .
My RCZ is from 2010, I was shocked by the amount of dirt I found under it ! All the rainwater and dirt that slide down between the double bubble rear window goes around the rubber and all dust and birds' collect there.
I suggest to do this job! It is easy to remove and place back the rubber, there is no glue. Without the rubber is much easy to clean the groove and rotating the rubber is possible to wash it outside the boot.
I'm going to place the camera near the rubber button that opens the trunk (sorry boot ) and I need to find a way to enter the wire in the boot.
Inside the boot, I removed the black plastic that covers the bottom part of the latch but under it, there is no way to reach the wiring of the rubber button or the license plate lights.
Is it possible to do this job without removing the entire bumper?
Extra story ...
Noticing all the dirt around the rubber of the boot I decided to clean it with a small sponge, water, and dish soap. Not satisfied with the first wash I decided to remove all the rubber .
My RCZ is from 2010, I was shocked by the amount of dirt I found under it ! All the rainwater and dirt that slide down between the double bubble rear window goes around the rubber and all dust and birds' collect there.
I suggest to do this job! It is easy to remove and place back the rubber, there is no glue. Without the rubber is much easy to clean the groove and rotating the rubber is possible to wash it outside the boot.