Dick Turpin

[Marmite]

Iv got a leak on my cold air side of the turbo , the rubber seal that sits in the end of the plastic pipe is just about had it so called my local friendly Peugeot dealer an was told the pipe a seal come as one ...... would you like to order that sir .... how much is it .... 800 plus vat ....no

 

[2retro]

£800! And they said comedy was dead!

 

[Marmite]

Trust me it’s not an so I done some digging an found a chap in London who does tuning bits for Peugeot’s an this seal is a common problem but as of yet you can’t get it for the R , but if I send him my one he can 3 d print it ... so that’s what I’m going to do but in the mean time I will get a silicone joiner an another jubilee clip an sleeve it for now

 

[DKZ5745]

If you can’t fix it with duct tape, you’re not using enough duct tape

 

[Flanners]

That is a tad steep, did you say you don't actually want the turbo charger with it?

 

[Marmite]

Come on seriously .... Peugeot dealer an sarcasm don’t mix

 

[Jh72i]

Just curious to know how much you were quoted for the 3d printing?

 

[Pedro]

Stick a Forge intake pipe on it I think there retailing around the £160 mark cheap fix & they last a zillion times longer than the plasdick crap

 

[Marmite]

where from ? Iv rang up about one an there out of stock apparently all the 308 gti owners are fitting them .

 

[Pedro]

Air intake for RCZ 200 on their website £123.64

 

[Pedro]

This is the hose on the site

 

[Woodso]

Iv got a leak on my cold air side of the turbo , the rubber seal that sits in the end of the plastic pipe is just about had it so called my local friendly Peugeot dealer an was told the pipe a seal come as one ...... would you like to order that sir .... how much is it .... 800 plus vat ....no

Did they think that you wanted a full engine?

 

[Marmite]

This is the hose on the site an

This is the hose on the site

Can u find one in stock for a 270 thp ?

 

[Pedro]

Basically its the same Air intake on the R ?

 

[Marmite]

Basically its the same Air intake on the R ?

Do you know the diameter of your intake on your turbo as I thought it was bigger on the r ??

 

[Pedro]

Never needed to measure mine its a 200 so not absolutely certain but I know Comkotes Tuning list the Forge silicone cold Air intake for the R together with RCZ 200 & 208 GTI for the Euro 5 Model which probably means Engine Spec so I would hazard a guess these hoses will fit the R because most car makers use stock pipework in most variants including performance models to save money on differentiating diameter hose couplings